univ ers a l ac i n p u t / ful l ra nge built- in a c tiv e pfc func t i on, pf 0. 9 8 typical h i gh e f f i c i enc y (up to 88%) output protections: ovp/scp/otp plc-035s070d plc-035s105d PLC-035S140D plc-035s175d plc-035s210d 35w atts single output led driver plc-035 d series q ualtek electronics corporation p p c page 1 of 3 output characteristics input characteristics protection environmental characteristics characteristics model rated current see note voltage range ripple and noise (max) note 1 voltage accuracy line regulation load regulation rise time hold-up time (typ.) voltage range frequency range power factor (typical) efficiency (typical) ac current (max) inrush current (max) leakage current over temperature (otp) over voltage (ovp) note 2 short circuit (scp) operating temperature operating relative humidity storage temperature vibration waterproof rating safety standards withstand voltage isolation resistance emc emission emc immunity life time mtbf (mil-hdbk-217f) dimension (lxwxh) note features: 0.35a (1) 33~100v 10% vo 5% vo 1% vo 3% vo 20ms max @ rated load 8.5ms min (110vac input, full load), 10ms min (220vac input, full load) 1.05a (3) 11~33v 1.40a (3) 8~24v 1.75a (3) 7~20v 2.10a (3) 6~18v 90vac~305vac 47hz-63hz >0.98 >0.92 88% 1.0a @ 100-277vac input full load 65a @ 230vac, 25c 0.6ma max @ 277vac >0.98 >0.92 86% >0.98 >0.92 85% >0.98 >0.92 84% >0.98 >0.92 84% 110c (temperature of internal components); shut down, auto recover after the temperature decreases 1.2~1.4vo long-term mode, auto recovery -35c~70c 10% rh to 100% rh -40c~85c, 5% to 100% rh non-condensing 10 to 300hz sweep at constant acceleration of 1.0g(breadth: 3.5mm) for 1 hour for each of the perpendicular axes x, y, z ip67 ul8750, compliance to ul1012 ul935, iec61347 l/n-gnd: 4kv, l-n: 2kv i/p-o/p: >100m ohms / 500vdc / 25c / 70% rh compliance to en55022(cispr22) class b, en61000-3-2 class a, en61000-3-3 compliance to en61000-3-2, 3 en61000-4-2, 3, 4, 5, 6, 8, 11, en61547 more than 50,000hrs (25c, 80% load) more than 550,000hrs (25c, 80% load) 199x42.5x34mm 1. ripple & noise: measured by 20 mhz bandwidth oscilloscope and the output paralleled with a 0.1 uf ceramic capacitor and a 1 0 uf electrolytic capacitor. 2. latch mode: the power supply shall return to normal operation only after the power is turned on again (1) non-class 2 output (usr & cnr) (2) class 2 output (usr); non-class 2 output (cnr) (3) class 2 output (usr & cnr) lightning protection plc-035s245d 2.45a (3) 5~15v >0.98 >0.92 83% 0.70a (2) 17~50v >0.98 >0.92 86% plc-035s035d waterproof (ip67) plc-035s045d 0.45a (1) 26~78v >0.98 >0.92 87% constant current design 5 year warranty 110vac 220vac plc-035s290d 2.90a (3) 4~12v >0.98 >0.92 82% class 2 power unit (see note) cb dimming control
35w atts single output led driver plc-035 d series q ualtek electronics corporation p p c iso-9001 com p a n y www. qualteku sa.com page 2 of 3 dimming control the dimmer control may be operated from an input signal of 1 ? 10 vdc. implementation: dc input i o / i r v s vdim 0% 2 0% 4 0% 6 0% 8 0% 100% 0 1 2 3 4 5 6 7 8 9 1 0 1 1 v di m ( v ) i o /ir notes: 1. io is actual output current and ir is rated current. 2. if the dimming function is not used, please short 10 v output pin (black) and 1-10 v input pin(red). the output current is about 92% ir when the 1-10v input pin is oating. 3. for the driver to operate properly, the load voltage must be maintained above the minimum voltage threshold (approx. 50% of the max. output voltage for any given model). 4. the dimming voltage can be tuned down to less than 1v, and the output current will be decreased to about 10% ir; but the connected leds may icker. keeping dimming voltage greater than 1v is strongly recommended. 5. do not connect the gnd of dimming to the output; otherwise, the led driver will not work normally. plc-035sxxxd 1-10v v dim+ (red) dim- (black) 1-10vdc gnd black white yellow/green ac/l ac/n ac/g led lamp vout (-) vout (+)
35w atts single output led driver plc-035 d series q ualtek electronics corporation p p c iso-9001 com p a n y www. qualteku sa.com page 3 of 3 mechanical specifications unit: mm 0 2 0 4 0 6 0 8 0 1 0 0 - 3 5 - 2 0 - 5 1 0 2 5 4 0 5 5 7 0 a m b i e n t t e m per a t ure( c ) load( % ) 0 2 0 4 0 6 0 8 0 1 0 0 9 0 1 2 0 150 1 8 0 2 1 0 2 4 0 2 7 0 300 3 3 0 i n p u t v o l t a g e ( v ) l o a d ( % ) d e r a t i n g c u r v e a m b i e n t t e m p e r a t u r e v s . l o a d ac input (18awg/3c sjow) black (ac l) white (ac n) yellow/green (gnd) dc output (18awg/2c sjow) white (v+) black (v-) dimming red (v+) black (v-)
|
